But this article is all about hardware, so before diving into it, might be worthy to refresh memory with the previous series of our hardware OC guides:NV’s TurboBoost functionality is also very sensitive to Traditionally, Kingpin-tier cards have provisions for extreme overclocking, but those are not limiting or making the card any worse as a daily driver. Password from the archive is ipromisenottoRMAthiscard. Press gently on corners for good adhesion to the frame.Unlatch the connector by a gentle lift of the gray lever straight up.Plug keyed 8-pin cable into both interface board and Use two longer screws to attach assembled frame to card.Make sure all connectors aligned correctly and locked firmly.Now boot the system with card installed and configure As you already know, regular hardware health monitoring software is usually unable to show real voltages supplied to the If you want to enjoy maximum fan speeds that 90.02.30.00.79 version provide, you can flash it into “Normal” or “OC” position instead, to maintain thermal protection mechanisms and safety. Image 3: I/O interface bracket with all display output portsImage 7: Card with removed Hybrid cover and Asetek pump assemblyImage 14: Molex 26-01-3116 MiniFit-Jr. current rating specs.Table 1: Power measurement demo system specificationImage 17-18: Measurement scope with attached probesImage 21: Power readout during 3Dmark TimeSpy benchmark game sceneImage 24: Overclocked run with stock voltage/VRM settingsImage 25: Power Limit Target set at 100 percent, 360W for Image 26: Power Limit Target set at 144 percent, 520W for Image 27: Left is power limiter set 520W, right is stock 360W settingImage 28: Power readout in 3Dmark GT1, with increased Image 31: Animation on different loadline settings, Level 0, 2, 5, 8, 10, 11 and Auto/L10.Image 33: Internal design of integrated PowerStage. They are rather an additional option for fine-tuning when doing serious extreme overclocking, than a requirement for everyday daily driver OC.PX1 must be running in background to allow readout for Rest of the items, like fan speeds, voltages, temperature monitors are only configured by PX1, after which onboard This section guides you thru the installation of such kit in steps.

These work completely independent from software/BIOS and in real-time. This is no usual review of a graphics card, it is yet another technical guide focused on design details and various OC features. Keep an eye on temperatures! Data provided in this guide was verified on multiple cards to best effort, but slight variations in numbers or results for graphics adapters are still possible due to different test conditions and running environment.Redistribution and use of this article, any parts of it or any images or files referenced in it, in source and binary forms, with or without modification, are permitted provided that the following conditions are met:All information posted here is hosted just for education purposes and provided Front I/O connections follow the similar layout as on previous cards of this series, featuring full support for Turing TU102 available outputs. That should be no limits to overclock TU102 It is actually quite easy to test.

If card start crashing in result – one can measure how much this Table 7 illustrating actual frequency scaling in respect to temperature from one In 24/7 daily overclocking using stock Hybrid or full-cover HydroCopper waterblock general suggestion is to leave Kingpincooling.com designed new extreme cooling container called This guide doesn’t cover extreme cooling insulation and condensation preparation of the card itself, as there are different ways to do this and everyone has a preferred method. In modern games and benchmarks like 3Dmark Time Spy or Port Royal graphics memory overclocking is just as important as the Since GDDR6 memory is now provided by multiple manufacturers, with This means that if you provide a slight bump in memory voltage, at around 1.45-1.50 Please note that running high voltages (hint: over 1.55 V) on your cards memory for extended periods of time (weeks, months) may degrade the IC’s slightly so this is not advised for continuous use, but rather reserved for benchmarking/competition purposes.